top of page

Iso-static press

Warm isostatic press is used to seal multiple layers of film in vacuum packaging bags, which are then placed inside a chamber. A servo hydraulic mechanism is used to move the chamber and the material into a hot water sealing cylinder environment. The high-pressure boosting pump increases the water pressure inside the chamber to a high level, and temperature and pressure are evenly applied to the components inside the pressure cylinder. This equipment is used for pressing multiple layers of ceramic capacitors and other films to enhance the physical and electrical properties of the products.

BSLLC-isostatic-press-1.jpg

  1. The working principle of the warm isostatic press involves using components such as a high-pressure vessel, heating system, cooling system, pressure control system, and safety protection system. 

  2. Suitable for pressing green laminates ranging in size from 4" to 8".

  3. Multiple sealed green laminates can be processed simultaneously.

  4. Maximum pressure range of 40-70 MPa ±0.5 MPa.

  5. Adjustable pressure holding time in three stages, ranging from 0 to 3000 seconds.

  6. Maximum operating temperature up to 85°C.

  7. Constructed entirely from stainless steel for enhanced durability.

  8. Easy replacement of sealing rings.

BSLLC-480ip technicals

Specification                   

​

Capacity:                  typically 60 laminates per cycle 

Cylinder diameter:    250 - 450 mm

Cycle time:                5-30min 

Pressure range:        0 - 40 or 70 MPa 

bottom of page